APC EP Zero ARF User Manual download pdf (Page 9)

❏❏2.Test fit one of the wing hinges in the wing.The outer

bearing should be flush with the wing tip.When satisfied with

the fit, epoxy the hinge in place. Be careful to avoid getting

epoxy into the open bearings.

❏❏3. Slide the loose carbon rod through the bearings.

❏❏4. Test fit an aileron onto the carbon rod as shown. If

satisfied with the fit, glue the aileron to the carbon rod using

CA. DO NOT glue the aileron to the bearings.The rod must

freely rotate in the bearings, so the aileron must only be

glued to the carbon rod.

❏ 1. Remove the screws and servo arms from all of your

servos. Enlarge the hole in the center of the extender until

the head of the servo screw fits through.

❏ 2. Trim the mounting posts off of the servo as shown in

the photo.

❏ 3.Place the original servo arm over the screw, and glue the

top of the arm to the extender with CA.Some servo arms have

small flanges projecting from the top. If your servo arms have

these flanges, sand them off before gluing.

Install the Servos

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

APC EP Zero ARF User Manual Page 9