APC MGE Galaxy 300 User's Guide download pdf (Page 46)

UPS Network Management Card 2 User’s Guide37

Environmental Monitoring

Note: If you install a Dry Contact I/O Accessory, AP9810, at your Network Management

Card, the Environment tab displays two top menu bar options, Universal I/O and

Environment. Except where noted, the settings described in this chapter are available for

both options.

Overview Page

The Overview page lists the status of environmental monitoring devices associated with the AP9635

Network Management Card on a Symmetra-series or MGE Galaxy UPS.

Note: The AP9635 can only have one universal sensor attached at a time. Depending on

which sensor is attached, a subset of the following headings will be displayed.

Heading Displayed Information

Temperature

and Humidity

Lists all sensors and, for each sensor, the alarm status, temperature currently recorded, and

humidity (if supported) currently recorded. For detailed status or to reconfigure a sensor's

parameters, click the sensor's name.

Input Contacts Lists each enabled input contact and its alarm status and current state (open or closed). For

detailed status of an enabled input contact or to reconfigure that contact's parameters, click

the name of the contact.

Note: To view or configure the parameters of a disabled contact, or to enable it, you must

access the interface page for that contact through Input Contacts on the left navigation

Output Relay Lists the alarm status and the current state (open or closed) of the output relay of the

integrated Environmental Monitor. For detailed status of that output relay or to reconfigure

its parameters, click its name.

Recent

Environmental

Events

The Recent Environmental Events field lists, in reverse chronological order, the most

recent environmental events. To view the entire event log, click More Events at the lower

right.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 104 105

No comments

APC MGE Galaxy 300 User's Guide Page 46