APC MGE Galaxy 300 User's Guide download pdf (Page 85)

76Network Management Card User’s Guide

Device IP Configuration Wizard

Capabilities, Requirements, and Installation

How to use the Wizard to configure TCP/IP settings

The Device IP Configuration Wizard configures the IP address, subnet mask, and default gateway of one

or more Network Management Cards or American Power Conversion network-enabled devices (devices

containing an embedded Management Card). You can use the Wizard in either of the following ways:

• Remotely over your TCP/IP network to discover and configure unconfigured Management Cards

or devices on the same network segment as the computer running the Wizard.

• Through a direct connection from a serial port of your computer to a Management Card or device

to configure or reconfigure it.

System requirements

The Wizard runs on Microsoft Windows 2000, Windows Server

2003, and Windows XP operating

systems.

Installation

To install the Wizard from the Utility CD:

1. If autorun is enabled, the user interface of the CD starts when you insert the CD. Otherwise, open

the file contents.htm on the CD.

2. Click Device IP Configuration Wizard and follow the instructions.

To install the Wizard from a downloaded executable file:

1. Go to www.apc/tools/download.

2. Download the Device IP Configuration Wizard.

3. Run the executable file in the folder to which you downloaded it.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 104 105

No comments

APC MGE Galaxy 300 User's Guide Page 85