990-1054A, 08/01 User’s Manual EnglishAPC Smart-UPS® 2200VA/3000VA 3U Rack Mount Uninterruptible Power Supply 230VAC/120VAC
8 4. Turn on all connected equipment (loads). To use the UPS as a master ON/OFF switch, be sure all connected loads are switched on. The loads will
9 3: OPERATION INDICATORS AND CONTROLS ON THE SMART-UPS The APC Uninterruptible Power Supply (UPS) is designed to prevent blackouts, brownouts, sag
10 SELF-TEST Automatic Self-Test The UPS performs a self-test automatically when turned on, and every two weeks thereafter (by default). Refer to th
11 Voltage Trim This LED illuminates to indicate the UPS is compensating for a high util-ity voltage. Voltage Boost This LED illuminates to indicat
12 SMART-UPS REAR PANEL The rear panel has the input and output connectors, computer interface port, and default setting but-tons for the low battery
13 To reduce UPS sensitivity, press the voltage sensitivity button. Use a pointed object (such as a pen) to do so. Press the button once to set sensi
14 ON-BATTERY OPERATION The Smart-UPS switches to battery operation automatically if the utility power fails. While running on-battery, an internal a
15 4: USER CONFIGURATION ITEMS NOTE: SETTING THESE ITEMS REQUIRES SOFTWARE OR OPTIONAL HARDWARE. FUNCTION FACTORY DEFAULT USER SELECTABLE CHOICES
16 NOTE: SETTING THESE ITEMS REQUIRES SOFTWARE OR OPTIONAL HARDWARE. FUNCTION FACTORY DEFAULT USER SELECTABLE CHOICES DESCRIPTION High Transfer Poin
17 5: STORAGE AND MAINTENANCE STORAGE STORAGE CONDITIONS Store the UPS covered and flat (rack mount orientation) in a cool, dry location, with its
18 6: TRANSPORTING YOUR SMART-UPS REMOVING THE UPS FROM THE RACK Always DISCONNECT THE BATTERY before shipping the UPS to avoid damage during tran
19 7: TROUBLESHOOTING Use the chart below to solve minor UPS installation problems. Also refer to the APC web site. Con-tact APC for assistance wit
20 PROBLEM AND POSSIBLE CAUSE SOLUTION ALL INDICATORS ARE LIT AND THE UPS EMITS A CONSTANT BEEPING Internal UPS fault. Do not attempt to use the UPS
21 SERVICE If the unit requires service, do not return it to the dealer. Instead, follow these steps: 1. Review the problems discussed in the Troubl
22 8: CONTACT, REGULATORY, AND WARRANTY INFORMATION CONTACTING APC Refer to the information provided at the APC Internet site: http://www.apc.com/s
23 DECLARATION OF CONFORMITY LIMITED WARRANTY American Power Conversion (APC) warrants its products to be free from defects in materials and workman
1 1: SAFETY INFORMATION American Power Conversion Corporation (APC) is the leading national and international manufac-turer of state-of-the-art uni
2 anesthesia ventilators, infusion pumps, and any other device designated as “critical” by the U.S.F.D.A. Hospital grade wiring devices and leakage c
3 BATTERY SAFETY This equipment contains potentially hazardous voltages that may cause personal injury if handled incorrectly. This equipment must b
4 2: INSTALLATION The UPS has a “rack” design so it can be mounted in a 19-inch (46.5 cm) equipment rack. Hardware is provided. UNPACKING 1. Inspe
5 5. Connect the battery and attach the front bezel. 6. Connect the equipment and power to the UPS. 7. Turn on the UPS. INSTALLING THE MOUNTING RA
6 3. Locate the battery module handle at the top of the battery face plate . 4. Be careful during this step—the battery module is heavy. Pull the
7 CONNECTING THE BATTERY AND ATTACHING THE FRONT BEZEL 1. Facing the front of the UPS, locate the battery cables and the UPS battery connector ja
Comments to this Manuals