APC SY30K40F Datasheet download pdf

990-4063F-001

07/2007

*990-4063F-

Installation

Symmetra PX 10-40 kW 208 V

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Warning: ALL safety instructions in the Safety Sheet

990-2984 must be read, understood, and followed when

installing the UPS system. Failure to do so could result in

equipment damage, serious injury, or death.

Warning: The UPS system has no built-in disconnection

devices for AC output and DC input. An AC output over-

current protection and AC output disconnect must be

provided by the customer.

Warning: After the UPS has been electrically wired, do not

start it up. Start-up is commissioned to APC-authorized

personnel only.

Caution: For customer-supplied external batteries, over-

current protection and a disconnection device for the battery

circuits must be provided.

Note: Ensure that the unit is in its final location

prior to the installation.

Cable Entry

Rear Cable Entry



Loosen the screws to remove the plate.



Punch holes as required and reinstall the panel before mounting the

wiring hardware.

Bottom Cable Entry



Loosen the screws to remove the plate.



Punch holes as required and reinstall the panel before mounting the

wiring hardware.

AC Input, AC Output, and Ground

Cable Landings

Caution: Ensure clockwise phase rotation and neutral

location.

Caution: Power terminal lug diameter is 8 mm. Torque value

is 6 Nm..



Connect power input and output wiring to terminate as shown. Route

the input and output cables in separate conduits.



Make ground connections as shown.





Emergency

Power OFF

Switch

Keep EPO

wire routing

isolated and

use separate

EPO conduit

Output

Input

DC Input

(Optional XR)



mergency

ower OFF

witch

eep EPO

ire routing

solated and

se separate

PO conduit

Output

Input

DC Input

(Optional XR)



1 2 3 4

Summary of Contents

Page 1 - Installation

990-4063F-00107/2007*990-4063F-InstallationSymmetra PX 10-40 kW 208 VIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSWarning: ALL safety instruct

Page 2 - APC Maintenance Bypass Panel

2EPO Switch WiringThe UPS must be connected to either a dry contact or a 24 Vdc Emergency Power Off (EPO) switch.The EPO circuit is considered Class 2

Page 3 - Specifications

3APC Maintenance Bypass Panel installation and wiring procedureMount the APC Maintenance Bypass Panel (MBP) on a wall close to the UPS according to t

Page 4 - Contact Information

4Recommended current protection.Input: 175 Amp. 3-Pole AC circuit breaker with 30 kAIC. Note: If your installation does not include an Isolation Tran

Comments to this Manuals

No comments

APC SY30K40F Datasheet

Browse online or download Datasheet for Uninterruptible power supplies (UPSs) APC SY30K40F. APC SY30K40F Symmetra PX 30kW Scalable to 40kW Rack-mountable UPS User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) APC SY30K40F