APC UXI 1000 User Manual

990-2688A 02/2006 User Manual EnglishAPC Smart-UPS® RT – UXI/UXICH 3000/5000 VA 220/230/240 VAC Tower/Rack-Mount 3U Uninterruptible Power S

8 Feature Function Cold Start This is not a normal condition. When there is no utility power and the UPS is off, press and hold the button to pow

9 USER CONFIGURABLE ITEMS NOTE: SETTINGS ARE MADE THROUGH SUPPLIED POWERCHUTE SOFTWARE, OPTIONAL SMART SLOT ACCESSORY CARDS, OR

10 NOTE: SETTINGS ARE MADE THROUGH SUPPLIED POWERCHUTE SOFTWARE, OPTIONAL SMART SLOT ACCESSORY CARDS, OR TERMINAL MODE. FUNCTION F

11 CONNECT THE EPO (EMERGENCY POWER OFF) OPTION The output power can be disabled in an emergency by closing a switch connected to the EPO. Adher

12 TERMINAL MODE TO CONFIGURE UPS PARAMETERS Terminal Mode is a menu driven interface that enables configuration of the UPS and allows configuratio

13 MAINTENANCE AND SERVICE INFORMATION Battery Replacement See your dealer or contact APC at the Web site, www.apc.com for information on replac

14 TROUBLESHOOTING Use the table below to solve minor installation and operation problems. Refer to the APC Web site, www.apc.com for assistance wi

15 PROBLEM AND POSSIBLE CAUSE SOLUTION BYPASS LED ILLUMINATES The bypass switch has been turned on manually or through an accessory. If bypass

16 REGULATORY AND WARRANTY INFORMATION Regulatory Agency Approvals and Radio Frequency Warnings 220, 230, 240 V MODELS This equipment has been test

17 Declaration of Conformity

18 APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways: • Ref

1 Introduction The APC Smart-UPS® RT is a high-performance, uninterruptible power supply (UPS) that provides protection for electronic equipment

2 ATTACH THE BEZEL TO THE UPS HARDWIRING INSTRUCTIONS 5000 VA MODELS ONLY: • Wiring must be performed by a qualified electrician. • Adhere t

3 BASIC CONNECTORS serial com Power management software and interface kits can be used with the UPS. Use only cables approved by APC. Any othe

4 CONNECT THE EXTERNAL BATTERIES Battery Safety Read and adhere to the following warnings when installing or servicing the external batteries. Fai

5 THIRD PARTY BATTERY SOLUTION Batteries must be Sealed Lead-Acid type. Use 50 A, 250 VDC fuses with an Interrupt rating of ≥ 20,000 A. Ensure

6 CONNECT EQUIPMENT AND POWER TO THE UPS 1. Connect equipment to the UPS. 2. 3000 VA models: Using a power cord, plug the UPS into a two-pole, th

7 OPERATION Load SMART-UPS RT FRONT DISPLAY Battery Charge Indicator Description Online The Online LED illuminates when the UPS is drawing