APC ACRD200 Installation Manual download pdf (Page 40)

InRow RD Fluid Cooled Operation and Maintenance32

Control console

After you log on at the control console, as described in“Local access to the control console” on page 30

or “Remote access to the control console” on page 31:

1. Choose Network from the Control Console menu.

2. Choose

TCP/IP from the Network menu.

3. If you are not using a

BOOTP or DHCP server to configure the TCP/IP settings, select the Boot

Mode menu and then select Manual boot mode.

4. Set the System

IP, Subnet Mask, and Default Gateway address values. (Changes will take effect

when you log out.)

5. Press

ENTER to return to the TCP/IP menu.

6. Press

CTRL+C to exit to the Control Console menu.

7. Log out (option 4 in the Control Console menu).

Note: If you disconnected a cable from the local computer during the procedure

described in “Local access to the control console” on page 30, reconnect that cable and

restart the associated service.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

No comments

APC ACRD200 Installation Manual Page 40