APC ACRD200 Specifications download pdf (Page 30)

InRow Fluid Cooled RD Installation22

Leak sensor (optional)

Install one leak sensor (AP9325). To extend the

leak sensor length, add up to three additional leak

sensors (AP9326).

1. Connect the leak sensor to the equipment

using the leak detector port as shown.

2. Position the leak sensor inside or outside the

equipment.

3. Route the leak sensor to the outside through

either the bottom plate or the door.

4. Secure the leak sensor wire to surfaces using

tie wraps and tie wrap holders (provided with

the leak detector).

na1584a na2760a

AP9325

na2676a

Leak detector port

na2675a

Note: Install leak sensors on a

clean surface, and do not allow

them to touch metal that is in an

air stream.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

No comments

APC ACRD200 Specifications Page 30