APC ACAC76128 Manual download pdf (Page 6)

Automatic Floor Pressurization Sensor for Uniflair CW — Installation6

tLAN connection

1. Using a screwdriver, remove the Analog Selection cover on the controller inside the unit.

2. Cut or pry out the pre-cut plastic section (right-side) from the cover to access the tLAN card slot.

3. Aligning the connector pins, insert the tLAN card into the slot and push into place, making sure

the card is pushed all the way up against the two plastic supports on the UPC1 case.

CAUTION

HAZARD TO EQUIPMENT

Circuit boards contained within this unit are sensitive to static electricity. Use one or more

electrostatic-discharge device while handling the boards.

Failure to follow these instructions can result in equipment damage.

CAUTION

HAZARD TO EQUIPMENT

Be sure all pins on the circuit board are properly seated and not bent or touching other

pins.

Failure to follow these instructions can result in equipment damage.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

APC ACAC76128 Manual Page 6