APC AP9924 User Manual download pdf (Page 14)

12 Wire Harness: Installation

Connect to the Battery Management System

Install the Battery

Management System

Install the Battery Management System in a battery cabinet, in a rack or

enclosure, or on top of the battery cabinet. The system must be installed

in a location that is safe, convenient, and accessible for connection

procedures.

String connection

After attaching the wire harnesses to the batteries and securing the

harnesses to the cabinets or racks, connect the battery strings to the

Battery Management System.

1. Plug the connector for String A into the right rear of the Battery

Management System in the port marked Battery/Power Input A.

2. If applicable, plug the connector for String B into the left rear of

the Battery Management System in the port marked Battery

Input B.

See also

For instructions and safety information on installing the

Battery Management System (AP9921X and AP9921XS),

see the Battery Management System Installation and Quick

Start manual (990-1649A), included with your Battery

Management System. You can also obtain the manual and

other documentation for currently available models of the

Battery Management System at www.apc.com by searching

for the product's part number (e.g., AP9921X).

Note

Verify that the ON/OFF button is in the OFF position on

each Battery Management System before plugging in

connectors.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

APC AP9924 User Manual Page 14