APC NBRK0550 Installation Guide download pdf (Page 13)

NetBotz Wireless Temperature Sensor Installation Guide

Using the Reset Button

Overview

The reset button on the side of the Wireless Temperature Sensor is used to

reboot the sensor, or reset the sensor to the factory default settings.

Reboot. When the reset button is given a short press (less than 3 seconds), the

Status LED flashes green, and the sensor reboots with the current settings in

place.

Reset to factory defaults. Press and hold the reset button for at least 5

seconds. The Status LED flashes green, and after about three seconds, changes

to solid red until the button is released. The sensor will reset, erase its current

settings, and restore the factory default settings.

Note: During the initial 45-second startup time, the reset button is

disabled. Once startup is complete, the button functions normally.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

APC NBRK0550 Installation Guide Page 13