14
NetBotz Wireless Sensor Pod 180 Installation Guide
End Device LED activity
To conserve battery power, the End Device will attempt to join the network
after waiting the following number of seconds: 5, 15, 30, 60, 120, 300, 300,
600, 1200.
If the attempts to join the network fail, the End Device will scan the network
every six hours to re-try the connection. If an End Device cannot join the
network after approximately 24 hours, it will reboot and attempt to join the
network again.
To force an attempt to join the network, press the reset button.
Using the Reset Button
The Reset button on the side of the Wireless Sensor Pod is used to reboot the
pod, or reset the pod to the factory default settings.
To protect against false push button attempts, there is no effect if the Reset
button is pressed for less than 100 milliseconds.
Reboot. Press and hold the Reset button for no more than 3 seconds. The
Status LED will flash green.
After you release the button, the status LED will rapidly flash yellow for about
40 seconds, turn solid yellow for 10 seconds, then flash a quick green, yellow,
red LED sequence. The pod will operate in the mode in which it was configured
before the reboot.
Reset to factory defaults. Press and hold the Reset button for at least 5
seconds. The status LED will rapidly flash green, and after about 5 seconds,
change to solid red.
Release the Reset button when the LED is solid red. The pod will reset, erase its
current settings, and return to Router mode, the factory default.
LED Behavior Meaning
Flashes yellow twice every 3 seconds Searching for network
Flashing yellow, then solid yellow Booting
Solid green for 5 seconds, then off Joined the network
Off Joined the network, or has not joined the
network and is conserving battery
power.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals