APC Network Management Card AP9617 User's Guide download pdf (Page 89)

USER’S GUIDE

Network Management Card

The carriers option. Configure TAP carriers.

TAP mode

Setting Description

TAP Carrier Select the service provider that this pager uses from the TAP service providers

configured through the carrier option.

Pager

Number

The numeric identifier of this pager, i.e., its TAP ID, usually the pager’s phone

number. Some TAP IDs also include the area code. Check with the TAP carrier.

See these related topics:

• Configuring event actions to enable or disable paging for an event, set the

time to wait before a page is sent, and set the interval for repeating a page.

• Conversion of event codes

for conversion of Network Management Card

event codes to default Out-of-Band Management Card event codes

• Paging message formats for the format of messages displayed on each

type of supported pager.

Setting Description

Name The name of a TAP service provider. You can configure up to four.

Dial

String

The dial string (Example: 9,15556789000).

Include the following, in order:

• Any numerals (e.g., 9) required to access an external telephone line. A comma to

cause the modem to pause to wait for a dial tone.

• The telephone number of the TAP carrier gateway, provided by the carrier.

Parity The parity required for a connection by modem to a TAP paging terminal of this TAP

carrier, as provided by the carrier: Even (the default), Odd, or None.

Data

Bits

The number of data bits required for a connection by modem to a TAP paging terminal

of this TAP carrier, provided by the carrier: 7 (the default) or 8.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 137 138

No comments

APC Network Management Card AP9617 User's Guide Page 89