APC SUA1500X93 User Manual download pdf (Page 4)

Connecting Equipment and Power to the UPS

SMART-UPS REAR PANEL

230V M

ODELS 120V/100V MODELS

Plug in the battery connector .

2. Connect equipment to the UPS. Note: Do not connect a laser printer to the UPS. A laser

printer draws significantly more power than other types of equipment and may overload

the UPS.

3. Add any optional accessories to the Smart-Slot .

4. Using the power cord, plug the UPS into a two-pole, three-wire, grounded receptacle only.

Avoid using extension cords.

• 230V models: A utility connector plug is included for use on servers with permanently at-

tached power cords.

• 120V/100V models: The power cord is permanently attached to the rear panel of the UPS.

5. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, be sure all con-

nected equipment is switched ON. The equipment will not be powered until the UPS is turned

on.

6. To power up the UPS press the

button on the front panel.

• The UPS charges its battery when it is connected to utility power. The battery charges to

90% capacity during the first three hours of normal operation. Do not expect full battery run

capability during this initial charge period.

• 120V Models: Check the site wiring fault LED located on the rear panel. It lights up if the

UPS is plugged into an improperly wired utility power outlet. Refer to Troubleshooting in

this manual.

7. For additional computer system security, install PowerChutePlus

UPS Power Management and

Diagnostic Software.





1 2 3 4 5 6 7 8 9 ... 17 18

No comments

APC SUA1500X93 User Manual Page 4