!
Remove the equipment from the pallet.
Ensure that the mounting stabilizers are in the up
position.
Attach the ramp to the pallet. Secure the ramp metal
brackets in the cutouts on the pallet.
With two people, one on either side of the unit, firmly hold
the front and rear of the unit. Carefully push the unit onto
the ramp, and to the floor.
Move equipment to the installation site.
Lower the mounting stabilizers to the floor to secure the unit.
Optional Seismic Anchoring: The unit may be anchored by
reattaching the four shipping brackets and bolting these to
the floor.
§
§
§
Install Battery Modules, If Applicable
5
Install battery modules in the lowest empty
applicable bays for your configuration. Install
remaining modules from the bottom upward.
Note
4
Transport the UPS to the Installation Site
3
Caution
Caution
§
§
Two people are required to move the UPS due to its
weight.
The mounting stabilizers should remain up until the
UPS is off of the ramps.
Battery modules are heavy. Two people are required
to handle a battery module due to its weight.
Install power modules in the appropriate bay locations for your
configuration.
Slide the module into the frame until the front of the
module is fully seated behind the safety catch .
Slide the latch up and tighten the captive screw .
Install Power Modules, If Applicable
3.1
3.2
3.3
4.1
4.2
!
Note
§ UBC calculations require a 3/8” diameter Trubolt
wedge anchor, embedded 3” into a concrete slab.
Refer to appropriate codes for specific requirements
that would apply to this particular installation.
§
3.4
P
B
B
2
2
B
B
2
2
B
B
2
2
B
2
B
2
B
2
B
B
1
1
B
B
1
1
Determine battery orientation. Each battery module will be
Installed in one of two orientations, B or B . Refer to
below.
For B1 orientation, position battery module with handles
on the top and right side of the module .
For B2 orientation, position the battery module with
handles on the top and left side of the module .
Slide the battery into the battery bay until the front of the
battery is behind the safety catch .
Check that each battery module is in the connected
position. Use a coin to turn the battery switch
counterclockwise to the ON position .
12
§
§
5.1
5.2
5.3
P
P
P
P
(21 pages)
(68 pages)
(13 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals