Apc iSCSI SATA II User Manual download pdf (Page 39)

[39]

3.5.2 NIC

Select “NIC” to change IP addresses of iSCSI data ports. There are two gigabit LAN

ports to transmit data. Each of them must be assigned one IP address in multi-homed

mode.

The screenshot above shows the 2 iSCSI data ports. Each of them is set to static IP.

LAN1 has Jumbo Frame enabled.

IP settings:

User can change IP address by moving mouse to the gray button of LAN port, click

“IP settings for iSCSI ports”. There are 2 selections, DHCP (Get IP address from

DHCP server) or Static (Static IP address).

Default gateway:

Default gateway can be changed by moving mouse to the gray button of LAN port,

then click “Become default gateway”. There is only one default gateway.

MTU / Jumbo frame:

MTU (Maximum Transmission Unit) size can be enabled by moving mouse to the gray

button of LAN port, click “Enable jumbo frame”.

WARNING: The MTU size of network switch/hub and HBA on

host must be enabled. Otherwise, the LAN connection can not

work properly.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 92 93

No comments

Apc iSCSI SATA II User Manual Page 39