APC AP5202 Specifications download pdf (Page 14)

10 KVM Switch — Installation and Quick Start

How to Apply Power

To apply power for a mutiple-switch system:

1. Plug in the power cable for the first KVM station. Wait for the switch to discover and display its

station ID on the Station ID LED. (The station ID for the first station is 01, the ID for the

second station is 02, the ID for the third station is 03, and so on.)

2. Plug in the power cables for each KVM Switch on the system in order of second station, third

station, and so on. In each case, wait for the station ID to be discovered and displayed on the

current KVM Switch before plugging in the next one.

3. After all the KVM Switches are running, apply power to the computers.

Powering off and restarting

Always follow this procedure after turning off the KVM Switch.

1. Remove power from all connected computers.

2. Wait 10 seconds, and then plug in the KVM Switch.

3. Apply power to the computers only after the KVM Switch is running.

Note

Unplug the power cord of any computer with the Keyboard Power On function

enabled; otherwise, the station continues to receive power from the computers.

Note

If you shut down more then one station, apply power to the highest-numbered

station first, continuing down to the lowest-numbered station.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

APC AP5202 Specifications Page 14