APC SYPM2KU Installation Manual download pdf (Page 20)

Install battery modules just prior to running the Symmetra RM. The battery modules

discharge slowly when loaded prematurely and can be damaged permanently.

Each battery module weighs 21.8 kg (48 lbs). Two people are required to install or remove

battery modules.

Battery Module: With one person on either side of the battery module, lift the

module, and slide it completely into the frame to engage the internal electrical

connector. The top of each battery module has a tab to align the module

connector with the connector inside the bay. This tab ensures that only battery

modules will fit into the bay.

Tighten the two (2) screws to secure the module.

Position battery modules in the bays on the right before filling bays on the left.

Power Module: Lift the power module, and slide the module into a bay until

flush with frame to engage the internal connector. The side of the power module

has a lever  to help align the connector on the module with the connector inside

the bay. It also locks the power module in place.

Tighten the two (2) screws to secure the module.

Install cover plates, included with the unit, over any unused bays.

Connect Equipment to the Symmetra RM

Power is distributed to the connected equipment via the power distribution panel (PDU) on the rear panel of the

Symmetra RM. Labeling on the rear panel indicates the circuit breaker/outlet groups.

220/230/240 (L1-N-G) PDU Panel 200/208 (L1-L2-G) PDU Panel

Eight (8) x IEC-320-C13

Two (2) IEC-320-C19

Two (2) L6-20

One (1) L6-30

Figure 8: Power Distribution Panels

• Use your equipment’s power cord to connect to the UPS.

• Turn on all connected equipment (the equipment will not be powered until the Symmetra RM is turned on).

• Add accessories for the accessories slot. See the literature accompanying the accessory for details.

This UPS is equipped with an accessory slot. See the APC website (apcc.com) for available

accessories.

If a standard accessory is installed on this UPS, follow the installation instructions included with

the accessory.



1 2 ... 15 16 17 18 19 20 21 22

No comments

APC SYPM2KU Installation Manual Page 20