APC AP9423U Datasheet download pdf (Page 17)

InfraStruXure Manager 13

How to Restore Access to the InfraStruXure

Manager Server

If the username or password used for local, Administrator access becomes unknown, or RADIUS

only is selected in the “Authentication Settings” display and a RADIUS server is unavailable, you

can use the following procedure to restore access to the InfraStruXure Manager server.

1. Connect a computer to the hub on the private network. That computer must have the

InfraStruXure Manager client installed. If it does not, connect to the InfraStruXure Manager

server and select to install the client, when prompted.

2. Reboot the InfraStruXure Manager server.

3. Use the InfraStruXure Manager client (step 1) to connect to the InfraStruXure Manager server.

4. When the “Server Log On” display appears, use

admin (lowercase) as the Username, and apc

(lowercase) as the Password, to log on to the server.

5. Select Authentication Settings in the System Management Menu to correct the problem that

required using this procedure:

–Click Configure Local Users to use the “Configure local users” display to define a username

and password for Administrator access.

– Change the Authentication Method setting to Local only.

Note

This may require physically disconnecting and reconnecting InfraStruXure

Manager at its input power source.

Note

If a logon attempt fails, try again; the InfraStruXure Manager server may not

have finished restarting. After the “Server Log On” display appears, you must

log on within about eight minutes, or you must repeat step 1 through step 4.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

No comments

APC AP9423U Datasheet Page 17