APC Slicon User Manual

October 201078-8140-1581-0-C3M™ No Polish Connector 8800-APC/ASSM SC/APC, Angle Splice, 250/900-µmInstructions

3M and Fibrlok are trademarks of 3M Company. Important NoticeAll statements, technical information, and recommendations related to 3M’s products are b

2Contents1.0 Summary...

31.0 Summary1.1 3M™NoPolishConnector8800-APC/ASterminates250µmor900µmsingleberswithSC/APCinterfaceandanglespliceforsuperiorop

42.0 Connector Preparation2.1 Priortoeachtermination,cleanalltools,includingberholder,withalint-freeclothandreagent-gradeisopropyl

5 Inthisinstance,usetheberholders'clamptoprohibitthebufferfrommovingorstretchingduringthestrippingprocess.Placetheberin

63.9 Closethecleaverclamp#1rst.Thisprocesssetstheappropriatecleavelength.3.10 Closethecleaverclamp#2.Note: Ensurethereisnobe

73.15 Verifythe8mmcleavelengthagainbyusingthelengthgaugeontheassemblybase.The8mmcleavelengthismeasuredfromtheendofthe900

84.5 Whentheberholderispushedtowardtheconnectorandstops,theberbowshouldbeseenasbelow.Theberwillbowandliftthemiddlecover

96.0 3M™ No Polish Connector (NPC) Re-termination6.1 Tore-terminatetheNPCconnector,removetheconnectorfromthecouplingontheactuationtool