APC SYPM2KU Installation Manual download pdf (Page 15)

CHAPTER 3: INSTALLATION

Unpacking

APC has taken care to design robust packaging for your product. However, accidents and damage may occur

during shipment.

Inspection

Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage. The packaging is recyclable;

save it for reuse or dispose of it properly.

Contents

The shipping package contains the UPS, one PowerView display bezel, three blank bezels, the mounting rail kit

(containing the mounting rails, and hardware), one blank panel kit (containing five blank panels, screws and

instructions), and a literature kit.

Placement

Sm art-UPS

The Symmetra RM is designed for use in a data center or other

office environment. Install it in a protected area that is free of

excessive dust, corrosion, conductive contaminants, and has

adequate air flow. Do not operate the UPS where the

temperature and humidity are outside the specified limits.

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the warranty.

Installing the Symmetra RM

Installing the Symmetra RM is a five-step process:

1. Position the Symmetra RM where it will be used. (This step includes mounting it in a rack if desired.)

2. Connect the Symmetra RM to its power source.

3. Wire the Emergency Power Off (EPO) switch.

4. Install modules into the Symmetra RM frame.

5. Connect equipment to the Symmetra RM.

This section describes each step in detail.

Position the Symmetra RM

Do not install the battery module(s) in the frame until you are ready to power up the

Symmetra RM. Failure to do so can result in a deep discharge of the batteries, which may

cause permanent damage.

Mounting rails are included with the Symmetra RM. The rails support the unit in the rack and provide adequate

air flow.

The Symmetra RM requires two people to install due to its weight.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

APC SYPM2KU Installation Manual Page 15