9/11
Section 4— Mounting Instructions for LXr Pro
To install the HP LXr Pro into an APC NetShelter, follow the steps in Table 6 below.
3 To install the shelf to the slide/rail
assembly, refer to the HP Net-
Server Rack Mount Kit instruc-
tions, Step 2, “Attaching the Base
to the Rails.”
Note
: You will need to use M6 ×
18mm screws, M6 cup washers,
and M6 caged nuts in the top and
bottom holes of the filler panels
and ears, in place of HP-supplied
Timmerman nuts and decorative
screws. The middle hole is inacces-
sible.
Note: APC offers a Cable Hoop
Kit (AR8113) for use with the
J1455A shelf. It replaces the HP
cable management brackets.
Table 6: Installation Procedure for LXr Pro
Step Action Figure
1 Align the attached mounting studs
of the HP slides to the bottom
holes in the mounting rails. Fasten
each HP slide to the mounting rail,
using the HP-supplied M6 locking
nuts.
Table 5: Installation Procedure for J1455A
Step Action Figure
Comments to this Manuals