APC NetBotz Rack Sensor Pod 150 Installation Manual download pdf (Page 11)

7NetBotz Rack Sensor Pod 150 Installation Manual

Connect Sensors

Only connect sensors supported by the appliance to which the NetBotz 150 is connected. See the

installation and quick configuration manual included with your appliance.

Caution: Only connect approved devices to ports on the NetBotz 150 as directed in this

manual. Plugging in other devices may result in equipment damage.

Connect APC and third-party sensors to the six ports labeled Sensors on the NetBotz 150.

• Third-party dry contact sensors require the NetBotz Dry Contact Cable (NBES0304). To connect

a sensor to the cable, follow the instructions provided with the sensor and the instructions

provided with the cable.

• Standard third-party 0-5 V sensors require the NetBotz 0-5 V Sensor Cable (NBES0305). To

connect a sensor to the cable, follow the instructions provided with the sensor and the instructions

provided with the cable.

• If a sensor cable is not long enough, use an RJ-45 coupling (provided with some sensors) and

standard CAT-5 cabling to extend the cable up to 15 m (50 ft) for a Temperature/Humidity Sensor

(AP9335TH) or a Temperature Sensor (AP9335T) and up to 30.5 m (100 ft) for all other

supported sensors.

Configure and Monitor Sensors

Once your system is installed and receiving power, configure sensors and begin monitoring your system

using the software interface for the appliance.

See your appliance installation and quick configuration manual for system installation details

and for instructions on accessing the software interface of the appliance.

Upgrade the NetBotz 150

Firmware upgrades for NetBotz 150s are included with firmware upgrades for NetBotz appliances.

When you upgrade firmware for the appliance to which the NetBotz 150 is connected, the NetBotz 150

firmware will be updated automatically, if required.

Note: The NetBotz 150 Identifier # LED shows 88 during a firmware upgrade. During the

upgrade, data from sensors connected to the NetBotz 150 will be invalid.

For more information on firmware upgrades, see your appliance user’s guide. For details on

how to access your appliance user’s guide, see “Additional documentation” on page 1.

Clean the NetBotz 150

To clean the device, gently wipe surfaces with a clean, dry cloth.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

APC NetBotz Rack Sensor Pod 150 Installation Manual Page 11