Apc 60-80kW User Manual download pdf (Page 60)

60 Installation Guide APC Silcon 60-80kW 400V UPS

990-4051

Options/Accessories

6.4.1 Relay Board/Relay Functions

NOTICE!

If alarm mode “Communication to controller lost” is active, ALL relays will indicate failure.

Relay Number Message Alarm-trigging Events

1 ## (X002) Mains outside limits Mains voltage RMS outside limits

Mains wave form (fast detector) outside limits

Mains frequency outside limits

2 ## (X003) Bypass outside limits Bypass voltage RMS outside limits

Bypass wave form (fast detector) outside limits

Bypass frequency outside limits

3 ## (X004) Output outside limits Output voltage RMS value outside limits

Output wave form (fast detector) outside limits

Output frequency outside limits

4 (X005) System overload Output load exceeding 100%

Delta inverter current limiter active

Main inverter current limiter active

5 (X006) Fan fault Blocked or faulty fan

6 (X007) Equipment

high temperature

Static switch temperature too high

Main inverter temperature too high

Delta inverter temperature too high

Magnetics temperature too high

Isolation transformer (option) temperature too high

Battery temperature too high

7 (X008) MCCB battery off Battery MCCB/Fuse not closed or released

8 (X009) Normal operation UPS running in normal operation mode(status)

9 ## (X010) Battery operation UPS running in battery operation mode(status)

10 ## (X011) Bypass operation UPS running in bypass operation mode(status)

11 ## (X012) Stand-by operation UPS in stand-by mode

(Hot stand-by - parallel systems only)

12 (X013) Service bypass

operation

Service bypass switch active

13 ## (X014) Boost charge

operation

UPS boost-charging on battery

14 (X015) Battery voltage

outside limits

DC voltage too high (shut down)

DC voltage below warning level

DC voltage too low (shut down)

15 (X016) Battery condition

fault

ABM has detected weak battery condition

ABM has detected defect battery

(ABM = Advanced Battery Monitor)

16 ## (X017) Common fault All alarms as mentioned above

(except relays 8+9+10+11)

Internal power supply fault

System locked in operation mode

Internal memory fault

Internal communication fault

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

Comments to this Manuals

No comments

Apc 60-80kW User Manual Page 60

Comments to this Manuals

Related products and manuals for Tools Apc 60-80kW