APC AP9215 Datasheet download pdf (Page 6)

Installation

PowerView is connected directly to the UPS through a single interface

cable (PN 940-0110) included with the PowerView unit. Follow the

steps below to connect PowerView to the UPS:

1. Connect the modular RJ45 plug on the end of the interface cable

to the connector at the rear of PowerView.

2. Check the rear of the UPS to determine whether there is a cable

already connected to the 9-pin computer interface connector. If

there is a cable already connected to this connector, shut down

any UPS monitoring software running on the host system, then

loosen the thumb screws and remove the existing cable. If there is

no cable connected, continue with Step 3.

3. Connect the male end of the 940-0110 cable to the computer in-

terface connector at the rear of the UPS and secure it with the

thumbscrews.

4. If it was necessary to remove a cable in Step 2, connect the re-

moved cable to the female connector on the 940-0110 cable and

tighten the thumb screws. If no cable was removed, the unused

connector may be left unconnected.

PowerView may be mounted to the wall with screws using features on

the back or it may be mounted with the supplied hook and loop fas-

teners. A template for mounting PowerView to the wall is supplied at

the end of the manual. PowerView will also sit upright on a flat sur-

face by folding out the wire bail on the rear of the unit.

Figure 4 PowerView Interface Cable

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

APC AP9215 Datasheet Page 6