APC Smart-UPS C 1000VA LCD 120V Specifications download pdf (Page 8)

Smart-UPS C 1000/1500 VA 120 Vac Tower6

LED status indicators

LCD status indicators

System Faults

The Smart-UPS will display a fault message in the event of an internal system fault.

Status LED Audible Indicator On

Audible Indicator

Terminates

Power On

The UPS is supplying utility power

to connected equipment.

The Online LED illuminates

green.

None N/A

On Battery

The UPS is supplying battery power

from the internal battery pack.

The Online LED illuminates

amber.

The UPS beeps 4 times

every 30 seconds.

The beeping stops when utility

power is restored or the M

UTE

button is pressed for 2 seconds.

System Fault

The UPS detects an internal system

fault.

System Fault LED illuminates

red.

Constant tone The alarm stops when the

P

OWER

O

N

/O

FF

button is

pressed for 2 seconds to trigger a

Fault Reset.

Site Wiring Fault

The building wiring presents a shock

hazard that must be corrected by a

qualified electrical.

Site Wiring Fault LED flashes

red.

None N/A

Status LCD Icon Audible Alarms Audible Alarm Terminates

On Battery

The UPS is supplying battery power to the

connected equipment.

Beeps 4 times every 30

seconds.

The beeping stops when utility

power is restored or the UPS is

turned off.

Utility Power Overload

An overload condition has occurred while

the UPS is operating on utility power.

Constant tone The alarm stops when nonessential

equipment is disconnected from the

outlets or the UPS is turned off

Battery Power Overload

An overload condition has occurred while

the UPS is operating on battery power.

Constant tone The alarm stops when nonessential

equipment is disconnected from the

outlets or the UPS is turned off.

Low Battery

The UPS is supplying battery power to the

connected equipment and the battery is

near a total discharge state.

Continuous beeping The beeping stops when utility

power is restored or the UPS is

turned off.

Battery Fault

The UPS is operating on utility power, but

the battery is not functioning properly. The

battery has reached the end of its useful

life.

N/A Replace the battery.

System Fault

The UPS has experienced an internal fault.

N/A Identify the fault message on the

display and refer to “System

Faults” .

F01 Output Short Circuit

F02 Output Overload

F03 AVR Relay Weld

F04 Output Over Voltage

F05 Unit Over Temperature

F06 Inverter

bu088b

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments