APC SMC1000I + WBEXTWAR3YR-SP-02 Datasheet download pdf (Page 10)

9Smart-UPS C 1000/1500 VA 120/230 Vac Tower

Display interface features

1000/1500 VA

120 Vac

1000/1500 VA

230 Vac Description

On Line: The UPS is supplying conditioned utility power to connected

equipment.

Green mode: The UPS is operating at the most efficient level, bypassing unused

AVR components while acceptable utility voltage is present. The UPS will enter

and exit Green mode automatically and will not compromise power protection.

Load Capacity: The load capacity percentage is indicated by the number of load

bar sections illuminated. Each bar represents 20% of the load capacity.

Estimated Run Time / Min: This indicates the battery runtime minutes that

remain if the UPS switches to battery power.

Battery Charge: The battery charge level is indicated by the number of load bar

sections illuminated. When all five blocks are illuminated, the battery is fully

charged. Each bar represents 20% of the battery charge capacity.

Overload: The equipment connected to the UPS is drawing more power than the

voltage rating allows.

Event: The event counter indicates the number of events that occurred to cause

the UPS to switch to battery operation.

Automatic Voltage Regulation (AVR): The UPS has an AVR boost and trim

feature that automatically regulates high or low levels of input voltage without

using battery power. The UPS also features AVR Bypass which temporarily

deactivates the AVR circuitry when the input voltage is within normal range.

This conserves battery power and helps to maximize battery life.

When illuminated, the UPS is compensating for low input voltage.

When illuminated, the UPS is compensating for high input voltage.

In: Input voltage.

Out: Output voltage.

System Fault: An internal system fault has occurred. The fault number will

illuminate on the display. Refer to “Display interface features” on page 9.

Mute: An illuminated line through the icon indicates that audible alarms are

disabled.

Battery Fault: The icon will flash to indicate that the battery is disconnected.

When the icon remains continuously illuminated the UPS has failed a

Self-Test or the battery is near the end of its service life and should be replaced.

Refer to “LCD status indicators” on page 8.

On Battery: The UPS is supplying battery backup power to the connected

equipment.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

No comments

APC SMC1000I + WBEXTWAR3YR-SP-02 Datasheet Page 10