APC SMT750I User Manual download pdf (Page 13)

11Smart-UPS 750/1000/1500/2200/3000 VA 100/120/230 Vac / 500 VA 100 Vac Tower

Customize the Main and Controlled Outlet Groups

Use the Configuration menus to change the Main Outlet Group and the Controlled Outlet Group settings.

Network Management Card Settings

These settings are available only on units that have a Network Management Card (NMC) and are set at the factory.

These settings can only be modified using an external interface, such as the NMC Web interface.

• NMC IP Address Mode

• NMC IP Address

• NMC Subnet Mask

• NMC Default Gateway

Function Factory Default Options Description

Name String

Outlet Group

Outlet Group 1

Edit these names using an external interface, such as the Network

Management Card Web interface.

UPS Name String UPS Outlets

Turn On Delay 0 sec

Set the value in

seconds

The amount of time the UPS or a Controlled Outlet

Group

will wait between receiving the command to

turn on and the actual startup.

Turn Off Delay

• 0 sec UPS Outlets

• 90 sec Controlled

Outlet Groups

Set the value in

seconds

The amount of time the UPS or a Controlled Outlet

Group

will wait between receiving the command to

turn off and the actual shut down.

Reboot Duration 8 sec

Set the value in

seconds

The amount of time the UPS or a Controlled Outlet

Group

must remain off before it will restart.

Minimum Return

Time

0 sec

Set the value in

seconds

The amount of battery runtime that must be available

before the UPS or

a Controlled Outlet Group will

turn on after a shutdown.

Load Shed On

Battery

Disabled

• Enable

• Disable

When the unit switches to battery power, the UPS

will disconnect power to the

Controlled Outlet

Group

to save battery runtime.

Configure this delay time, use the

LOAD SHED TIME

WHEN ON BATTERY setting.

Load Shed Time

when On Battery

1800 sec

Set the value in

seconds

The amount of time the outlets will function on

battery power before they will turn off.

Load Shed On

Runtime

Disabled

• Enable

• Disable

When the battery runtime falls below the specified

value, the

Controlled Outlet Group will turn off.

Configure this time using the

LOAD SHED RUNTIME

REMAINING setting.

Load Shed On

Runtime

Remaining

120 sec

Set the value in

seconds

When the remaining runtime reaches this level, the

Controlled Outlet Group will turn off.

Load Shed on

Overload

Disabled

• Disabled

• Enabled

In the event of an overload (greater than 107%

output), the

Controlled Outlet Group will

immediately turn off to conserve power for critical

loads. The Controlled Outlet Group

will only turn on

again with a manual command.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

APC SMT750I User Manual Page 13

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) APC SMT750I