APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 25)

SCSI to SATA II RAID Subsystem

User Manual

2.3.2 Lock Indicator

Every Drive Carrier is lockable and is fitted with a lock indicator to indicate whether

or not the carrier is locked into the chassis or not. Each carrier is also fitted with an

ergonomic handle for easy carrier removal.

When the Lock Groove is vertical, then the Drive Carrier is unlocked.

When the Lock Groove is horizontal, this indicates that the Drive Carrier is locked.

2.3.3 Disk Drive Installation

This section describes the physical locations of the hard drives supported by the

subsystem and give instructions on installing a hard drive. The subsystem supports

hot-swapping allowing you to install or replace a hard drive while the subsystem is

running.

a. Make sure the Lock Groove is in unlocked position. Press the carrier open

button and the Drive Carrier handle will flip open.

b. Pull out an empty disk tray. Pull the handle outwards to remove the carrier from

the enclosure.

Carrier

Open

Button

Drive

Carrier is

locked

Drive Carrier

is Unlocked

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 89 90

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 25