APC RAID Subsystem SCSI-SATA II User Manual download pdf (Page 41)

SCSI to SATA II RAID Subsystem

User Manual

Chapter 5 Configuration Utility Options

The subsystem has a built-in setup configuration utility containing important information

about the configuration as well as settings for various optional functions in the

subsystem. This chapter explains how to use and make changes to the setup utility.

Configuration Methods

There are three methods of configuring the subsystem:

• VT100 terminal connected through the controller’s serial port

• Front panel touch-control keypad

• Web browser-based proRAID Manager GUI

IMPORTANT: Only one method can be used to configure the

subsystem. Two methods can be used at the same time but the

other method will be in read-only mode.

5.1 Configuration through a Terminal

To start-up:

1. Connect a VT100 compatible terminal or a PC operating in an equivalent terminal

emulation mode to the monitor port located at the rear of the subsystem.

NOTE: You may connect a terminal while the subsystem’s power is

on.

2. Power-on the terminal.

3. Run the VT100 program or an equivalent terminal program.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 89 90

No comments

APC RAID Subsystem SCSI-SATA II User Manual Page 41