APC AP9604 Datasheet download pdf (Page 8)

4 Installation

The mounting brackets can be attached at

various positions along the side of the Triple

Chassis using the holes provided. Choose a

position that will not cause the mounted

Triple Chassis or the attached cables to

interfere with closing the cabinet door or to otherwise

protrude from the cabinet. If more than two mounting

holes are aligned, choose the pair that are farthest apart.

3. Mount the Triple Chassis into the NetShelter enclosure

with 4 caged nuts and machine screws (not supplied).

If the Triple Chassis is being installed in a

enclosure other than a NetShelter, use the

hardware that is appropriate for the

enclosure.

4. Connect the female end of the included cable to the 9-

pin male connector labeled “To UPS” on the front of the

Triple Chassis.

5. Connect the male end of the cable to the 9-pin female

computer interface port on the rear of the UPS.

6. If UPS monitoring is to be used, connect the required

cable (940-0024, not supplied) from the 9-pin

monitoring port on the front of the Triple Chassis to an

appropriate serial port on a computer, or to another card.

7. If additional power is needed (see "Power Consider-

ations" on page 5), connect the optional power adapter

output to the power port on the front of the

Triple Chassis.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

APC AP9604 Datasheet Page 8