Apc Command Line Interface User Manual download pdf (Page 35)

Command Reference: General Management

Command Line Interface (CLI) User’s Guide 31

uploadini

Syntax:

uploadini

Description: Upload an INI file, using

XMODEM, when you are accessing the CLI

through a serial connection. After the upload

completes:

• If there are any system or network changes, the

user interface of the Switched Rack PDU

restarts, and you must log into the CLI again.

• If you selected a baud rate for the file transfer

that is not the same as the default baud rate for

the Switched Rack PDU, you must reset the

baud rate to the default to reestablish

communication with the PDU.

Access: Administrator and device manager

(device-only user).

Parameters: None.

Output Format:

In the following output format, user input is in

bold, and additional instructions, which are not

displayed on the screen, are in italic.

-------------------------------------------------------------

Perform file transfer via XMODEM-CRC?

Enter 'YES' to continue or <ENTER> to cancel:

YES

------- File Transfer Baud Rate-----------------------

1- 2400

2- 9600

3- 19200

4- 38400

> 2

Change baud rate to 9600 and press <ENTER>...

Press

ENTER now.

In the terminal program (such as HyperTerminal)

browse to and select the .ini file to transfer and, if

requested, select XMODEM as the transfer

protocol. The following output is displayed:

Start XMODEM-CRC Transfer Now!

CCC

-------------------------------------------------------------

1536 bytes have successfully been transmitted.

If you selected a baud rate other than the default

9600 for the transfer, reset the baud rate to the

default after the transfer.

Error Message: E101

1 2 ... 30 31 32 33 34 35 36 37 38 39

Comments to this Manuals

No comments

Apc Command Line Interface User Manual Page 35

Comments to this Manuals

Related products and manuals for Hardware Apc Command Line Interface