Apc Network Management Card AP9617 User Manual download pdf (Page 10)

Quick Configuration

Overview

You must configure the following

TCP/IP

settings before the

Management Card can operate on a network:

•The

address of the Management Card

• The subnet mask

• The default gateway

TCP/IP

configuration

methods

Use one of the following methods to define the TCP/IP settings

needed by the Management Card:

• The APC Management Card Wizard (see “APC

Management Card Wizard” on page 11)

• A DHCP or BOOTP server (see “BOOTP & DHCP

configuration” on page 11)

• A local computer (see “Local access to the control

console” on page 14)

• A networked computer (see “Remote access to the

control console” on page 15)

Note

If a default gateway is unavailable, use the

address of a computer located on the

same subnet as the Management Card that

is usually running. The Management Card

uses the default gateway to test the network

when traffic is very light. See “Watchdog

Features” in the “Introduction” of the

Network Management Card User’s Guide

(.\doc\usrguide.pdf) for more information

about the watchdog role of the default

gateway.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

Apc Network Management Card AP9617 User Manual Page 10