®
®®
®
USER’S GUIDE
network management card
95
Reset UPS Defaults
This option resets the UPS to use the default EEPROM values.
Configure Parallel UPS parameters (Silcon UPS only)
Use this option, available only in the Web interface, to identify up to nine
different Silcon UPSs that you can then access through the hyperlink, View
the refreshing status page, in the “Status for UPS” page.
Caution
Before you use this option, make sure that resetting the
EEPROM values will not adversely affect the load equipment or
any shutdown sequence.
Setting Definition
IP Address Identifies the IP address of the Management Card of the Silcon
UPS to be monitored.
Monitor Name Identifies by name the Silcon UPS to be monitored.
Comments to this Manuals