APC NBWL0456 Installation Guide download pdf (Page 14)

NetBotz Wireless Sensor Pod 180 Installation Guide

Disconnecting a Coordinator

When you disconnect the Coordinator from the host appliance, all of the

sensors on the wireless sensor network display as offline. When you reconnect

the same Coordinator, it must be manually deleted and reconfigured in the

Wireless Sensor Setup task in the Advanced View. The network will then

restart, and the sensors will begin reporting data.

If you want to connect a different pod to the host appliance to become the

Coordinator, you must FIRST remove the extended address of the previous

Coordinator from the commission list.

See “Configuring the Coordinator” on page 9.

Maintaining sensor history. If you right-click a disconnected Coordinator

in the Navigation pane in the Advanced View and select “Delete Pod”, all of the

Wireless Sensor Pods will be deleted, including any sensor history related to

those devices.

To maintain your sensor history, remove the Coordinator using the Wireless

Sensor Setup dialog.

Warning: If a Coordinator is removed from the host appliance

after being configured as a serial device, it MUST be manually

deleted using the Wireless Sensor Setup dialog. You will not be

able to configure a Coordinator if the entry is not deleted, even

if the original pod is reconnected.

Internal sensor listing

When a Coordinator is selected in the Navigation Pane in Advanced View, the

following internal sensors are listed in the Sensor Pane (along with any attached

external sensors):

Sensor Description

Temperature The internal temperature sensor reading.

Humidity The internal humidity sensor reading.

Dew Point The calculated dew point.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

No comments

APC NBWL0456 Installation Guide Page 14