APC AP9612TH Datasheet download pdf (Page 7)

Environmental Monitoring Card 3

Installation

How to install

the card

First install your UPS, and then install the Environmental

Monitoring Card in a slot, as follows:

1. Shut down protected equipment and turn off the UPS.

2. Use a #2 Phillips screwdriver to remove the two screws

holding the plate that covers the card slot. Save the

screws and the plate.

3. Slide the card into the slot as shown in the following

figure. The faceplate of the card should be flush with the

front of the card slot.

4. Secure the card with the screws removed in step 2.

Warn

Failure to turn off the UPS could result in

damage to your Environmental Monitoring

Card.

Warn

Handle the card by the faceplate only. Do not

touch the exposed printed circuit board.

Warn

Inserting the card upside down can damage

the card. The sides of the printed circuit board

must align with the card guides in the sides of

the slot.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

APC AP9612TH Datasheet Page 7