APC AP5202 User's Guide download pdf (Page 27)

®®

USER’S GUIDE

kvm switch

Setting the Scan Interval. Use the Scan Duration setting of the OSD SET

function to set the amount of time Auto Scan waits on each port. You can

also change the scan interval before activating Hot Key Auto Scanning with

the following Hot Key combination:

1. Activate Hot Key mode by pressing

NUM LOCK and the hyphen key at

the same time.

2. Type

T and a number from 1 to 255 (the wait time, in seconds).

3. Press

ENTER.

Activating Auto Scan. To activate Auto-Scanning, enter the following Hot

Key combination:

1. Activate Hot Key mode by pressing

NUM LOCK and the hyphen key at

the same time.

2. Press

A. Hot Key mode stops automatically and Auto-Scanning begins.

How to pause Auto Scan. While in Auto Scan mode, pause scanning to

keep the focus on a particular computer by either pressing

P or left-clicking

the mouse. While Auto-Scanning is paused, the command line displays

Auto Scan: Paused.

To resume Auto-Scanning, press any key or left-click the mouse.

Use pausing if you want to keep the focus on a particular computer rather

than exit Auto Scan mode. With this method, you start from where you

stopped when scanning resumes. If you exit and restart, scanning begins

from the first computer on the installation.

To exit Auto Scan mode, press

ESC or SPACEBAR.

The letter T and the numbers display on the command line

as you type them. Use

BACKSPACE to erase an incorrectly

typed number.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

APC AP5202 User's Guide Page 27