APC AP9608 Installation Manual download pdf (Page 19)

Installation Manual

Command line interface

After you log on at the command line interface, as described in “Local access to

the command line interface” on page 13 or “Remote access to the command

line interface” on page 14, you can manually configure network settings.

1. Contact your network administrator to obtain the IP address, subnet

mask, and default gateway for the Network Management Card.

2. Use these three commands to configure network settings. (Text in italics

indicates a variable.)

a.tcpip -i yourIPaddress

b. tcpip -s yourSubnetMask

c. tcpip -g yourDefaultGateway

For each variable, type a numeric value that has the format

xxx.xxx.xxx.xxx.

For example, to set a system IP address of 156.205.14.141, type the

following command and press

ENTER:

tcpip -i 156.205.14.141

3. Type exit. The Network Management Card restarts to apply the

changes.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

APC AP9608 Installation Manual Page 19