APC AP95103202 Datasheet download pdf (Page 2)

MasterSwitch Power Receptacles continued

Warnings Exceeding the voltage or amperage limits for the individual

Power Receptacles could cause fire damage or shock.

Do not exceed the load capacity of the

UPS or branch circuit by

connecting more than one fully loaded Power Receptacle. To

calculate the expected load, consult the nameplate ratings of all

connected equipment.

You must maintain reliable grounding of all equipment. Pay

particular attention to supply connections other than direct

connections to the branch circuit.

Do not exceed the operating temperature or humidity limits

shown in “Additional specifications” on page 5. Note that the

ambient temperature in a rack environment may be greater than

the ambient room temperature.

When installing the Power Receptacles in a rack:

• Do not mount the receptacles in a location that impedes

the flow of air in the rack.

• Do not mount the receptacles in a way that loads the

rack unevenly, causing the rack to become unstable.

Disconnect the front panel power cord and the relay control

input cord before moving the Power Receptacle. Both cords

carry hazardous voltages.

Mounting

power

receptacles in a

rack

To mount Power Receptacles in a NetShelter enclosure or other

standard (

EIA 310-D) 19" rack, use the hardware provided with

the Power Receptacle Tray and perform the following steps in

the order given.

1. Plan the mounting location for the tray and each unit

within the tray. The figure on page 4 shows the tray

mounted at the rear of a NetShelter, at the same height

as the MasterSwitch, which has been mounted on the

front. Consider your need for proximity to the UPS and

to the attached load(s).

Note: You must install Power Receptacles near the attached

load(s), so that the outlet is easily accessible.

1 2 3 4 5 6 7 8

No comments

APC AP95103202 Datasheet Page 2