APC AP95103202 Datasheet download pdf (Page 3)

MasterSwitch Power Receptacles continued

Mounting

power

receptacles in a

rack, continued

2. Using a Phillips head screwdriver, remove the

four outermost

6-32 screws from the front panel of each

Power Receptacle to be mounted in the tray, as shown in

the figure below.

3. Remove blanking panels from the front of the Power

Receptacle Tray, as necessary.

4. Insert each Power Receptacle unit into one of the bays

of the tray, aligning the holes on front panel of the unit

with the holes in the flanges of the tray. Attach with the

four

6-32 screws removed in Step 2.

5. Attach a blanking panel to any empty bays, using four

screws (provided). See the figure on page 4 for an

example setup.

6. Place the mounting brackets on the side of the tray,

inserting the two tray studs into the slit of each bracket.

Slide the brackets forward to allow room for the power

cords that will be connected at the rear of the rack.

Attach using two

8-32 acorn nuts (provided with the

Power Receptacle Tray) for each bracket.

Remove Screws

1 2 3 4 5 6 7 8

No comments

APC AP95103202 Datasheet Page 3