APC PDPM138H-R Installation Guide download pdf (Page 18)

Configuration: Settings

12 Modular Power Distribution Unit – Operation 990-3054B-001

How to set the individual alarm thresholds

The Individual Load Cfg screens are used to set the alarm thresholds for a single Power Distribution

Module in the system.

It is also possible to set the settings for all modules at the same time. Refer to "How to set the

alarm thresholds for all Power Distribution Modules in the system".



Select Circuit Cfg on the Main Menu Screen, and

press

ENTER.



Select Individual Load Cfg and press ENTER.



Scroll through the modules/circuits to go to the

desired module/circuit. Press

ENTER to select a

specific module/circuit.



Change the settings for:

 Alarms: Select to enable or disable alarms.

 Alarm Thresholds: Select to change the

settings for Warning Thresholds, Critical

Thresholds, and Position Alarms.

 Reset to defaults: Select to reset to factory

defaults.

>Individual Load Cfg

>Mass Configuration

>Reset Ckt Defaults







Mod:>xx Cable:>yy

>Name/Location

>Alarm Configuration

>Alarms:>Enabled

Mod xx, Cable yy:

>Alarm Thresholds

>Reset to defaults



Module View Alarms

Load/Energy

Circuit Cfg Admin

Volt Meter

Log

Help

>Electrical Config

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

APC PDPM138H-R Installation Guide Page 18

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) APC PDPM138H-R