APC 1000XL VA Specifications download pdf (Page 9)

Smart-UPS C 1000/1500 VA 120/230 Vac Rack-Mount 2U8

System Faults

Feature Reference Guide

1000/1500 120 Vac 1000/1500 230 Vac

P00

Output Overload

P01

Output Short Circuit

P02

Output Over Voltage

P04

Unit Over Temperature

P06

AVR Relay Fault

P13

Inverter Fault

Note: Refer to the "Feature Reference Guide" on page 8 for a detailed description of the front panel buttons and icons.

For more information on System Faults, contact customer support at the APC Web site, www.apc.com/support.

Function Button

Timing

(seconds)

UPS

Status

Description

Power

Power On

0.2 Off

Press the POWER ON/OFF button to turn on the UPS. The UPS will

operate on AC power.

If AC power is not available the UPS will operate on battery power.

Power Off

2On

Press the POWER ON/OFF button to turn off the UPS.

Display

Status Inquiry

0.2 On

Press to verify the status or condition of the UPS. The LCD will

illuminate for 60 seconds.

Power Saving

mode

Continuous

Illumination

2On

The LCD will illuminate and the UPS will beep to confirm Continuous

Illumination mode is activated.

The LCD will extinguish and the UPS will beep to confirm that

Power Saving mode is activated. While in Power Saving mode, the

LCD will illuminate if a button is pressed or an event occurs, then

extinguish after 60 seconds of no activity.

Mute

Event Specific

0.2 On

Disable any audible alarms caused by an event.

Enable/Disable

2On

Enable or disable the audible alarms. The Mute icon will illuminate and

the UPS will beep once. The Mute feature will not activate unless the

UPS is operating on battery power.

Sensitivity

6Off

The Load Capacity icon will flash to indicate the UPS is in Program

mode. Use the

POWER ON/OFF button to scroll through and select Low,

Medium, and High sensitivity levels. The UPS will beep to confirm the

selection. Refer to Sensitivity adjustment settings on page 4 in this

manual.

Self-Test

2On

The UPS will automatically run a self-test of the internal battery when

the UPS is turned on.

A manual self-test can be run at any time while the UPS is operating.

Press and hold the

MUTE button, then press the DISPLAY button for 2

seconds until the system emits a short beep to indicate the UPS has

started a Self-Test.

Event Reset

0.2 On

When the Event screen is visible, press and hold the DISPLAY button,

then press the

POWER ON/OFF button to clear the AC failure event

counter.

Fault Reset

2Fault

After a fault has been identified, press the POWER ON/OFF button to

remove the visual indication and return to standby status.

su0 752a

su0752b

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

APC 1000XL VA Specifications Page 9

Comments to this Manuals

Related products and manuals for Power supply units APC 1000XL VA