APC LX Service Manual download pdf (Page 10)

HAPTER

3: M

ENU

OMMANDS

3. Remove the screws



securing the display bracket to the PowerView.

4. Disconnect the UPS cable

 from the RJ-45 port on the PowerView.



5. Connect the programming cable



(included) between the PowerView and the UPS cable.

• Attach the RJ-45 connector to the port on the rear of the PowerView.

• Connect the female DB-9 connector of the programming cable to a serial port on the computer.

•

Attach the UPS cable to the female RJ-45 connector on the programming cable.



6. Locate the language program file to be downloaded into the UPS.

Each language program file appears on the CD under the folder of its language (françois, español, etc.)

with a .bin extension. Program files for additional language support or code updates may be available

on the APC Web site.

7. Place the PowerView in programming mode by pressing simultaneously the three keys on the right

(

ESCAPE

HELP

, and

ENTER

) for about three seconds, until the PowerView emits a long beep.

• The LCD will display the Programming screen.

• To leave the Programming screen before starting a file transfer (step 6), press

ESC

until it beeps

(about one second).

8. Start HyperTerminal or another terminal emulation program on the computer.

• Set the communication parameters to 8 bits, no parity, no flow control, 1 stop bit, and 19,200 bps.

• After establishing a connection, use the Xmodem protocol to transfer the language program file from

the CD or your download folder to PowerView.

• When the file transfer is complete, the PowerView will reset itself and display the Startup screen in

the new language.

9. If the file transfer fails, PowerView will reset itself. Retry the file transfer by repeating steps 6 and7.

10. Quit the terminal session.

11. Disconnect the programming cable on the RJ-45 port on the PowerView.

12. Connect the UPS cable to the RJ-45 port on the PowerView

13. Install the display bracket to the rear of the PowerView by securing the two screws to the display.

14. With two hands, grip the display and gently snap the tabs onto the frame.

15. .Secure the PowerView display by tightening the two screws to the UPS frame.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comments to this Manuals

No comments

APC LX Service Manual Page 10

Comments to this Manuals

Related products and manuals for Power supply units APC LX