APC SX 24U Cabinet Specifications download pdf (Page 11)

7 NetShelter SX 24U Cabinet - Installation and Customization Manual

Level the Equipment

NOTE: The leveling feet at the corners of the equipment provide a stable base if the floor is uneven, but they

cannot compensate for a badly sloped surface.

1. Ensure the cabinet is in its intended location. Remove the front and rear doors.

See “Removal” on page 9 for instruction.

NOTE: Before removing the front door, unplug the ground wires and any other wire connections that

may interfere with the removal of the doors.

2. Insert a Phillips head screwdriver into the screw above the leveling foot. Turn the screw clockwise to

extend the leveling foot until it makes firm contact with the floor.

3. Adjust each foot and, using a level, adjust the feet until the cabinet is level and plumb.

4. Install the front and rear doors.

Remove the Casters and Leveling Feet (optional)

1. Lay the cabinet on its side.

2. Using a 10 mm socket wrench (not provided), remove the four hex nuts from each of the casters and

remove the casters.

3. For each leveling foot, use a Phillips screwdriver to turn the foot clockwise until it is released from the

frame.

NOTE: Remove all equipment from the cabinet before removing casters and leveling feet.

DANGER

HAZARD OF ELECTRIC SHOCK

When Installing the doors, remember to reconnect all ground and other connection wires.

Failure to follow these instructions will result in death or serious injury.

ns2304a

NOTES:

1. If loaded with equipment, a

13 mm open ended wrench

can also be used to lower the

leveling feet.

2. This method works best with an empty, or near empty

cabinet.

3. Door removal is not required if using the 13 mm open-ended wrench.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

APC SX 24U Cabinet Specifications Page 11