APC SX 24U Cabinet Specifications download pdf (Page 14)

NetShelter SX 24U Cabinet - Installation and Customization Manual10

Reverse the Front Door

NOTE: The front door can be reversed so that the door opens in the other direction. This procedure assumes

that initially, when facing the cabinet, the hinges are on the left and the door is opening from right.

ns1709a

1. Remove the handle by removing

the screw-plate. Pull the handle

from the door.

3. Locate the upper hinge on the cabinet frame. Remove the two

screws holding the hinge in place. Install the hinge onto the other

side of the cabinet frame. Repeat this step for the lower hinge.

4. Remove the hinges from the door

and install them using the set of

holes directly below where they

were originally installed. Rotate

the door 180 degrees and install

on cabinet

2. Disconnect the ground wire, and any other wire

connections. Remove the door from the frame.

See “Removal” on page 9 for more information.

5. Install the door to the hinges now on the reverse side of the cabinet

frame. See “Installation” on page 9 for instruction. Connect the ground

wire and any other wire connections previously disconnected.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

APC SX 24U Cabinet Specifications Page 14