Model H10990-2216 Copyright © 2005 American Power ConversionAll rights reserved. The APC AV logo is a registered trademarkof American Power Convers
- 2 -Safety PrecautionsPlease ensure you have read and understand all of the safety information located at the front of this manual. If you have any q
- 3 -Surge ProtectionThe H10 Power Conditioner provides a high level of surge protection for the voltage going into the unit, thus protecting the devi
- 4 -Front and Rear PanelsThe following sections describe the controls and indicators on the front and rear panels.Front Panel Controls and Indicators
- 5 -Switched On Status IndicatorIf illuminated, power is on at all outlets except those with a pro-grammed delay.Delayed On Status IndicatorIf illumi
- 6 -To set the Delay time for the sequenced outlets:Push the SEQ/AVR push button briefly; all LEDs are extin-guished, indicating the H10 is in delay
- 7 -Rear Panel Connectors and Circuit BreakerThe rear panel connectors for the H10 Power Conditioner are detailed in Figure 3. Each numbered callout
- 8 - AC-Powered OutletsThe H10 Power Conditioner provides for connection of up to twelve (12) AC-powered devices. The outlets are arranged according
- 9 -Surge Protected COAX/RF ConnectorsThe H10 provides surge protection for your CATV system, Cable Modem, DSS, or Antenna system. The surge protecti
- 10 -DC Trigger jacksWhen connected to a component acting as a DC trigger, that component controls turn on/off of the ‘delayed’ outlet banks. The H10
- 11 -InstallationThe installation of the H10 consists of the following steps:1. Make connections2. Apply power3. Set up the H10Make ConnectionsPrior
- 12 -Set Up the H10Using the front panel Dimmer and SEQ/AVR push buttons ( and , Figure 2) you can configure the following functions:• Dimmer Funct
- 13 -Technical SpecificationsThe following table contains the specifications for the H10.Item SpecificationINPUTInput Voltage Range for Opera-tion (o
- 14 -Federal Communications Commission (FCC) Compliance InformationThis device complies with Part 68 and Part 15 of the FCC rules. Operation is subj
- 15 -TroubleshootingThis section describes possible causes and solutions for the following problems:• Unit will not turn on.• “Wiring OK Indicator” L
- 16 -“Wiring OK Indicator” LED is not illuminated.Probable Cause: There are 3 reasons why this LED would not be illuminated:1. Reversed polarity ex
- 17 -Technical SupportInternet Address: http://www.apc.com/supportEmail Support: support.apcc.comToll free: (888) 88-APCAV
iSafety Information1. Read this manual - Read all of the safety and operating instructions before installingand operating this device.2. Keep this man
iiSafety Information (continued)16. Overloading - Do not overload the wall outlet where this device is being connected.Do not overload this device. En
iiiRegistration Verification ConfirmationBy registering your purchase now, it guarantees you will receive all the information and special offers you q
iv
vTable of ContentsSafety Information iProtect Your Investment iiiIntroduction 1Proven Expertise…Proven Reliability 1Safety Precautions 2Package Conten
vi
- 1 -IntroductionCongratulations on your purchase of APC’s H10 Power Conditioner (Figure 1). This unit will protect your high performance audio and vi
Comments to this Manuals