APC SURGEARREST PMF3S-A Instruction Manual download pdf (Page 6)

Proper installation is imperative to maximize the APC Modular Panel SPD’s

effectiveness and performance. The installer should follow the steps outlined

in this instruction manual to ensure proper installation.

disconnect only.

Inspect the entire shipping container for damage or signs of mishandling

before unpacking the device. Remove the packing material and further

inspect the device for any obvious shipping damage. If any damage is

found and is a result of shipping or handling, immediately file a claim with

the shipping company.

The device should be stored in a clean, dry environment. Storage

temperature is -40 to +65 °C (-40 to +149 °F). All of the packaging

materials should be left intact until the device is ready for installation.

UNPACKING AND

PRELIMINARY INSPECTION

STORAGE

ANGER

AZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC

FLASH

· Apply appropriate personal protective equipment (PPE) and follow safe

electrical work practices. See NFPA 70E.

· This equipment must only be installed and serviced by qualified

electrical personnel.

· Turn off all power supplying this equipment before working on or

inside equipment.

· Always use a properly rated voltage sensing device to confirm

power is off.

· Replace all devices, doors and covers before turning on power to this

equipment.

Failure to follow these instructions will result in death or

serious injury.

Read the entire

instruction manual before beginning the installation. These instructions are

not intended to replace national or local electrical codes. Check all applicable

electrical codes to verify compliance. Installation of surge suppressors should

only be performed by qualified electrical personnel.

NOTE: SPD s are designed for use on the load side of the service entrance

PACKAGING

APC MODULAR PANEL PRODUCTS Surge Protective Device (SPD)

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

APC SURGEARREST PMF3S-A Instruction Manual Page 6