Apc 600 User Manual download pdf (Page 7)

2.0 Safety! ENGLISH

Caution!

CAUTION!

■ To reduce the risk of electric shock, disconnect the Uninterruptible

Power Source from the mains before installing computer interface signal

cable (when used). Reconnect the power cord only after all signalling

interconnections have been made.

■ Connect the Uninterruptible Power Source to a two-pole, three-wire

grounding mains receptacle. The receptacle must be connected to

appropriate branch protection (fuse or circuit breaker). Connection to any

other type of receptacle may result in a shock hazard and may violate local

electrical codes.

■ This Uninterruptible Power Source has an internal energy source

(the battery) that cannot be de-energized by the user. The output may be

energized when the unit is not connected to a mains supply.

■ To properly deenergize the Uninterruptible Power Source in an

emergency, move the rear panel I/O switch to the O (off) position and

disconnect the power cord from the mains.

■ Avoid installing the Uninterruptible Power Source in locations where

there is water or excessive humidity.

■ Do not allow water or any foreign object to get inside the

Uninterruptible Power Source. Do not put objects containing liquid on or

near the unit.

■ To reduce the risk of overheating the Uninterruptible Power Source,

avoid exposing the unit to the direct rays of the sun. Avoid installing the

unit near heat emitting appliances such as a room heater or stove.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

No comments

Apc 600 User Manual Page 7