Thank You!Thank you for selecting the American Power Conversion SmartSlot Series Measure-UPS II. It has been designed for many years of reliable, main
See below for a typical hookup. Note that in this example system zone 1 is a normally closed motion zone with power for the passive infrared detector
5. Sensor SelectionMeasure-UPS II may be used with any dry contact closure type sen-sors. The Measure-UPS II sensor inputs are designed to monitor cir
6. MaintenanceMeasure-UPS II requires periodic maintenance. Confirm contact sens-ing using the sensor manufacturers recommended intervals and meth-ods
7. TroubleshootingProblem Possible Cause SolutionConstant Alarm on one or more unused zones.Unused zones not jumpered.Connect a wire between the COM a
8. ServiceIf the SmartSlot Measure-UPS II requires service:1. Check Measure-UPS II using the troubleshooting chart in section 7 before calling for ser
9. SpecificationsElectricalSmartSlot specification compatibleOperating voltage: 16 - 27 VdcOperating current draw: 30 mAdc (exclusive of anyattached s
10. Declaration of ConformityApplication of Council Directives: 89/336/EECStandards to Which Conformity is Declared: EN55022, EN50082-1Manufacturers N
Limited WarrantyAmerican Power Conversion (APC) warrants its products to be free from defects in materials and workmanship for a period of two years f
Contents1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 Installation . . . . . . . . . . . . . .
1. IntroductionThe SmartSlot Measure-UPS II performs temperature and humidity sensing, as well as contact monitoring.Measure-UPS II supports up to fou
Safety NoticeThe SmartSlot Measure-UPS II UPS accessory is intended solely for use in supplementary surveillance of equipment. APC does not recom-mend
2. InstallationUse the following procedure to install SmartSlot Measure-UPS II:1. Install and configure any software or hardware that will be used wit
Do not:• Cover any of the ventilation holes on the probe• Immerse the probe or place it where dew can be expected to form• Use the probe in an environ
3. Operation Check1. Confirm the basic operation of Measure-UPS II. Use the data reporting system (see hardware and software compatibility in sec-tion
4. Sensor Zone ConnectionsConnection InformationMeasure-UPS II supports normally open and normally closed loop systems, and allows mixing of normally
In order to avoid receiving alarm indications on unused zones, install a jumper wire between the COM and NC connectors for each unused zone.To use mor
Comments to this Manuals