APC Back-UPS Pro Specifications download pdf (Page 6)

Back-UPS BR900G-RS Installation and Operation6

Warnings and System Faults

Audible Warnings

Warning Icons

System Faults

Four Beeps Every 30 Seconds Back-UPS is running on battery. You should consider saving any work in progress.

Continuous Beeping Low battery condition and battery run-time is very low. Promptly save any work in progress,

exit all open applications, and shut down the operating system.

Continuous tone Battery Backup outputs are overloaded.

Chirps for 1 Minute every 5 hours Battery fails the automatic diagnostic test and should be replaced.

If these icons are

illuminated... This may be the problem.

The Back-UPS is operating on A/C power, but is overloaded. Disconnect one of the devices connected

to the Back-UPS. If the Overload icon stops flashing, the Back-UPS is no longer overloaded and will

continue to operate normally.

The Back-UPS is operating on battery power, but is overloaded. Disconnect one of the devices

connected to the Back-UPS. If the Overload icon stops flashing, the Back-UPS is no longer overloaded

and will continue to operate normally.

The Back-UPS is operating on A/C power, but the battery is not functioning properly.

Contact APC Customer Service to order a replacement battery.

The Back-UPS is operating on battery power and the battery power is getting low. Shut down all

connected equipment to avoid losing unsaved data. When possible, connect the Back-UPS to A/C

power to recharge the battery.

F01 On-Battery Overload Turn the Back-UPS off. Disconnect non-essential

equipment from the Battery Backup outlets and then

turn Back-UPS on.

F02 On-Battery Output Short Turn the Back-UPS off. Disconnect non-essential

equipment from the Battery Backup outlets and then

turn Back-UPS on.

F03 On-Battery Xcap Overload

Faults F03-F09 are not user serviceable. Contact APC

Technical Support for assistance.

F04 Clamp Short

F05 Charge Fault

F06 Relay Welding

F07 Temperature

F08 Fan Fault

F09 Internal Fault

bu088a

1 2 3 4 5 6 7 8 9 10

No comments

APC Back-UPS Pro Specifications Page 6